• Innovative 3-Ring Combination Design
• Independent Swivel Cheek Purchase (upper ring)
• Flat Leather NoseBand Connected to Synthetic Chin Strap with Nylon Cord
• 7/16" Bars Shaped in Pronounced Curve to Allow Comfortable Swallowing
• Copper Inlay on Inside of Bars to Encourage Salivation
• Sweet Iron Mouthpiece- Oxidizes with Moisture, Releasing Sweet Taste
• This is a Myler Level 2 Bit

Please Note: A Myler bit will normally measure 1/8” larger than the stated size because the Myler's believe that the bit should have at least 1/8” to 1/4” of bit on either side of the mouth.   

Combination System Design and Function:

The 3-ring combination bit uses 5 different pressure points to disperse rein pressure. Because the noseband and chin strap are connected through the purchase (upper ring), when the reins are engaged the horse first feels the nose, chin and poll pressure before the mouthpiece is engaged. The mouthpiece slides freely on the center ring for about 1" before reaching a stop, then engages to roll forward onto the tongue to disperse pressure. The overall effect is to give the horse ample opportunity to respond to the rider's rein signals, in addition to dispersing the rein pressure over multiple pressure points rather than concentrating on the bars or tongue.

The 3-ring shank offers three different rein positions: the big ring, the middle ring and the bottom ring for a variety of direct/indirect action and leverage options ideal for training a horse from start to finish!

Ergonomic Mouthpiece Design:

The unique curved bars of all Myler bits are ergonomically designed to accommodate the natural anatomy of the horse's mouth, wrapping the bars and lips instead of pinching. This curved design also provides significantly more space for the horse's tongue underneath the bit, allowing the horse to comfortably swallow when the reins are not engaged.

The Wide Low Ported Barrel mouthpiece is a curb mouthpiece that does not rotate onto the tongue, but instead sits solidly on the bars and lips of the horse's mouth, and is the Myler alternative to the traditional mullen mouthpiece. Unlike a traditional mullen, this mouthpiece offers a wide low port that allows the tongue to comfortably pass under the bit.

The 3/4" Low Port is not high enough to apply any palate pressure, but does not offer as much tongue relief as other Level 2-3 bits with higher ports, because the tongue is still somewhat restricted. However, this bit primarily applies bar/lip pressure, so though the tongue might be more restricted when the mouthpiece engages, little pressure is actually applied directly to the tongue.

Independent Side Movement:

The barrel at the center of the mouthpiece is not a roller, but rather a bushing that allows each side of the bit to move independently of the other. When the rider engages one rein on a traditional bit, the entire mouthpiece moves, creating a confusing signal for the horse. In comparison, when the rider engages one fixed rein using a Myler bit with ISM, the rider lifts only one side of the bit, giving a very clear, precise signal to the horse.

Myler Philosophy:

The creators of Myler Bits, Ron, Dale and Bob Myler, offer this philosophy behind each of their bits: The bit is a communication tool between the horse and rider, and in order to effectively communicate with the horse, the rider needs a bit which allows the horse to be relaxed. Keeping this in mind, the Myler Bitting System is based on the concept of tongue relief. Distributing tongue pressure more evenly than rival designs Myler's unique designs offer varying degrees of tongue relief for the horse depending on his level of training and his disposition. These degrees are identified by the "Level" noted for each bit.

Additional Questions: 

If you have any further questions regarding all of our bit options and what bit would best suit your horse feel free to call one of our knowledgeable customer service representatives at 800-620-9145!